View Single Post
Old July 21st, 2016, 10:51
Ecomike's Avatar
Ecomike Ecomike is offline
NAXJA# 2091
Join Date: Dec 2006
Location: MilkyWay Galaxy
Posts: 15,367
Re: Renix scanner port data question.

What you need is a high impedance analog volt meter to read it properly and do it at the sensor in case the wiring is compromised. Not sure yet what the MT-2500 display shows, have not tried mine yet. But if it is a live wave form it should be good for seeing what the signal looks like at the ECU. What the ECU sees, may not be what the O2 sensor data at the sensor is. I would never use a DVM for O2 sensor tests. The data is more like a sin wave.
Quote=8Mud: "Go ahead and put up the best fence you can build, I'll bet on some Mexican with a few dollars of nails and a pile of scrap lumber."
34 MPG , '85 2WD Cherokee Pioneer with custom installed, 64 hp, 2.2 L Nissan SD22 Diesel 5 spd Manual; & 4 Renix XJs, '87 Wagoneer 4.0, 4WD, 89-Cherokee, 4WD, '87 Cherokee 2WD, & '89 Cherokee Pioneer 2WD, all 4dr. #2091
Reply With Quote